Adheprint Strong 3D Printing Adhesive 250ml

Adheprint adhesive is designed for FDM 3D printers. Its main purpose is to improve bed adhesion when printing the first layers. The glue is clear and thick.

Preparing the platform: clean the printer's work surface of dust, old glue residue, or other contamination. Make sure the surface is dry and level.

Shake before use: shake the can vigorously for 10 seconds so the active ingredients mix evenly.

Applying the glue: hold the can upright, 15-20cm from the surface. Spray an even, thin layer of glue onto the print bed using a sponge or spatula. Wait 1-2 minutes for the surface to become slightly tacky.

Printing: start your 3D print, making sure the first layer settles evenly onto the prepared surface. Follow the temperature settings recommended for your bed/mat.

Cleaning: after printing, remove glue residue from the platform with a damp cloth or warm water.

Precautions:

• Use in a well-ventilated area
• Avoid contact with skin and eyes - rinse thoroughly with water if contact occurs
• Store the can in a dry place at +5°C to +30°C
• Don't apply the glue when the bed is very hot - it may damage your mat
• Don't spray near open flame or hot surfaces
• Keep out of reach of children!